RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT STOP LIGHT CONTROL RELAY (STOP RELAY)


    1. Remove the stop light control relay (STOP relay).

    2. Check both the relay case and the terminal for deformation and corrosion.

      OK
      No deformation or corrosion.
    3. A01UYLVE21
      Text in Illustration
      *1 Stop Light Control Relay (STOP Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Battery voltage not applied Below 1 Ω
      3 - 5 Battery voltage not applied 10 kΩ or higher
      3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the stop light control relay (STOP relay).