TIRE AND WHEEL SYSTEM INSPECTION

PROCEDURE


  1. INSPECT TIRES


    1. Check the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size Vehicle Speed

      Front

      kPa (kgf/cm2, psi)

      Rear

      kPa (kgf/cm2, psi)

      175/65R15 84H

      (Countries that use WVTA)

      		 Driving under 160 km/h (100 mph)

      230 (2.3, 33)*1

      250 (2.5, 36)*2

      220 (2.2, 32)*1

      240 (2.4, 35)*2
      Driving over 160 km/h (100 mph) 230 (2.3, 33) 220 (2.2, 32)

      175/65R15 84H

      (Countries that do not use WVTA)

      		 Driving under 160 km/h (100 mph) 230 (2.3, 33) 220 (2.2, 32)
      Driving over 160 km/h (100 mph) 230 (2.3, 33) 220 (2.2, 32)
      185/60R15 84H Driving under 160 km/h (100 mph) 220 (2.2, 32) 200 (2.0, 29)
      Driving over 160 km/h (100 mph) 230 (2.3, 33) 200 (2.0, 29)
      195/50R16 84V Driving under 160 km/h (100 mph) 220 (2.2, 32) 200 (2.0, 29)
      Driving over 160 km/h (100 mph) 240 (2.4, 35) 210 (2.1, 30)

      *1: Standard Pressure

      *2: ECO Pressure

    2. A01V0M5

      Using a dial indicator, check the tire runout of the tires.

      Maximum tire runout
      Vertical
      1.4 mm (0.0551 in.) or less
      Lateral
      2.0 mm (0.0787 in.) or less

  2. ROTATE TIRES

    A01V1ZVE03
    Text in Illustration
    *A Compact Spare Tire
    *B Full Size Spare Tire
    A01V0R7 Front

    Tech Tips

    Rotate the tires, as shown in the illustration.

  3. INSPECT WHEEL BALANCE


    1. Check and perform off-car balancing.


      1. A01UZ15

        Steel wheel:

        Maximum imbalance
        8.0 g (0.0176 lb)
      2. A01V0MGE02

        Others (Non-steel wheel):

        Maximum imbalance
        8.0 g (0.0176 lb)

        Note


        • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

        • Make sure to use a genuine Toyota balance weight.

        • Do not touch the adhesive part of the tape.

        • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

          Width (A)
          25 mm (0.984 in.)

        • Push the balance weight securely with your finger to adhere it to the desired position.

        • Do not reuse the balance weight.

        Tech Tips

        The inner side balance weight should be installed by clipping it to the rim.

    2. If required, perform on-car balancing.

      Imbalance after adjustment
      8.0 g (0.0176 lb) or less

  4. INSPECT FRONT AXLE HUB BEARING

    Click here

  5. INSPECT REAR AXLE HUB BEARING

    Click here