TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   
   

   1. Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

   2. Install the bolt.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

   3. Connect the connector to the tire pressure warning ECU and receiver.

2. INSTALL ROOF SIDE INNER GARNISH LH

   Tech Tips

   Use the same procedure as for the RH side Click here.

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Tech Tips

   Use the same procedure as for the RH side Click here.

4. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

   Click here

5. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

   Tech Tips

   Use the same procedure as for the RH side Click here.

6. INSTALL REAR FLOOR FINISH PLATE

   Click here

7. INSTALL FRONT FLOOR COVER LH

   Click here

8. INSTALL CENTER FRONT FLOOR COVER

   Click here

9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

   
   

   1. Install the rear door opening trim weatherstrip LH.

10. INSTALL REAR DOOR SCUFF PLATE LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

11. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)

    Click here

12. INSTALL SPARE WHEEL COVER (w/ Cover)

    Click here

13. INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

14. REGISTER TRANSMITTER ASSEMBLY ID

    Click here

15. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

16. PERFORM INITIALIZATION

    Click here