FRONT LOWER SUSPENSION ARM(for LH Side) REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

    A004EZ3

    1. Remove the clip and the castle nut.

    2. A004EH9E05

      Install SST to the threaded section of the lower ball joint.

      SST
      09960-20010   ( 09961-02060 )

      Note

      Make sure the upper ends of the threaded section of the lower ball joint and SST are aligned.

    3. Using SST, separate the front lower suspension arm sub-assembly LH from the front axle assembly.

      A004E4ZE07
      Text in Illustration
      *1 Center Nut - -
      *a String *b Molybdenum Grease Application Area
      *c Place the wrench here *d Turn
      SST
      09960-20010   ( 09961-02010 )

      Note


      • Apply molybdenum grease to the bolt threads and the tip of SST.

      • Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

      • Install SST so that A and B are parallel.

      • Be sure to place the wrench on the part indicated in the illustration.

      • Do not damage the lower ball joint dust cover.

      • Do not damage the drive shaft outboard joint boots.

      • Do not damage the front disc brake dust cover.

    4. A01UY0S

      Remove the 2 bolts and the front lower suspension arm sub-assembly LH.