STEERING KNUCKLE REMOVAL

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT AXLE ASSEMBLY

    Click here

  2. REMOVE FRONT AXLE HUB HOLE SNAP RING

    Click here

  3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  4. REMOVE FRONT DISC BRAKE DUST COVER


    1. A01UXMM

      Using "TORX" socket wrench T30, remove the 3 bolts and the front disc brake dust cover.

  5. REMOVE FRONT AXLE HUB BEARING

    A01V1ADE08

    1. Install the removed axle hub bearing inner race to the outer side of the front axle hub bearing.

    2. Using SST and a press, remove the front axle hub bearing from the steering knuckle.

      SST
      09223-15020
      09387-02010
      09950-60010   ( 09951-00630 )
      09950-70010   ( 09951-07100 )