STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB BEARING


    1. A01V0MXE01
      Text in Illustration
      *a Magnetic Rotor Side
      A01V0R7 Inside of the vehicle

      Using SST and a press, insert a new front axle hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.

      SST
      09950-60020   ( 09951-00710 )
      09950-70010   ( 09951-07100 )

      Note


      • Do not remove the inner race because the front axle hub bearing is built into the oil seal.

      • Do not use bearings that have been removed.

      • Do not wipe off any grease that has been applied to new bearings.

      • Do not bring magnets close to the magnetic rotor surface of the bearing.

      • Keep the magnetic rotor surface of the bearing free of foreign matter.

  2. INSTALL FRONT DISC BRAKE DUST COVER


    1. Using "TORX" socket wrench T30, install the front disc brake dust cover with the 3 bolts.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

  3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT AXLE HUB HOLE SNAP RING

    Click here

  5. INSTALL FRONT AXLE ASSEMBLY

    Click here