FRONT DRIVE SHAFT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

    A01V1ID

    1. Coat the spline of the front drive inboard joint assembly with ATF WS.

    2. Align the front drive inboard joint assembly splines, and using a screwdriver and a hammer, install the front drive shaft assembly LH.

      Note


      • Face the cut area of the front drive shaft hole snap ring downward.

      • Do not damage the oil seal.

      • Do not damage the inboard joint boot.

      • Make sure to center the front drive shaft assembly during installation to prevent damage to the front drive shaft hole snap ring.

      Tech Tips

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

  2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  3. INSTALL FRONT AXLE ASSEMBLY LH


    1. Push the front axle assembly LH out of the vehicle to align the spline of the front drive shaft assembly LH with the front axle assembly LH and insert the front axle assembly LH.

      Note


      • Do not push the front axle further out of the vehicle than is necessary.

      • Do not damage the outboard joint boot.

      • Check for any foreign matter on the speed sensor rotor and insertion part.

      • Do not damage the speed sensor rotor.

  4. INSTALL FRONT AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  5. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  7. INSTALL TIE ROD END SUB-ASSEMBLY LH

    Click here

  8. INSTALL TIE ROD END SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

    Click here

  10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  11. INSTALL FRONT SPEED SENSOR LH

    Click here

  12. INSTALL FRONT SPEED SENSOR RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  13. INSTALL FRONT AXLE SHAFT NUT LH


    1. Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut LH using a non-residue solvent.

      Note


      • Be sure to perform this work for a new front drive shaft.

      • Keep the threaded parts free of oil and foreign objects.

    2. Using a deep socket wrench 30 mm, install the front axle shaft nut LH.

      Torque:
      216 N*m  { 2203 kgf*cm, 159 ft.*lbf }
    3. A01UYID

      Using a chisel and hammer, stake the front axle shaft nut LH.

  14. INSTALL FRONT AXLE SHAFT NUT RH

    Tech Tips

    Use the same procedure for the RH side as for the LH side.

  15. ADD HYBRID TRANSAXLE FLUID

    Click here

  16. INSPECT HYBRID TRANSAXLE FLUID

    Click here

  17. INSPECT FOR HYBRID TRANSAXLE FLUID LEAK

  18. INSTALL ENGINE UNDER COVER RH

  19. INSTALL ENGINE UNDER COVER LH

  20. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  21. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here