SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL SHIFT LEVER ASSEMBLY


    1. A01V195E02

      Temporarily install the shift lever assembly to the vehicle with the 4 bolts.

      Note

      Make sure that the wire harness is not pinched by the shift lever assembly installation surface.

    2. Fully tighten the 4 bolts in the order shown in the illustration.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    3. Engage the 3 clamps to install the wire harness to the shift lever assembly.

    4. Connect the indicator light wire sub-assembly connector and shift lock control ECU sub-assembly connector.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01UYF3E04
      Text in Illustration
      *1 Nut
      *2 Lock
      A01V0R7 Rotate approximately 180°
      A01UY2W Push in

      Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.

      Note

      Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.

    2. A01V1BYE03
      Text in Illustration
      *1 Lock
      *a Protrusion
      A01V0R7 Push in

      Install the transmission control cable assembly to the shift lever assembly.

      Note


      • Install the transmission control cable assembly with the protrusion facing upwards.

      • After installation, make sure that the lock is projecting from A as shown in the illustration.

      • Make sure that the transmission control cable assembly is securely locked.

      Tech Tips

      As shown in the illustration, the transmission control cable for LHD models passes along the left side of the projection, while the transmission control cable for RHD models passes along the right side of the projection.

      A01V17PE02
    3. A01UZP2
      Text in Illustration
      *A for LHD
      *B for RHD
      *1 Transmission Control Cable
      *a Projection

      Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the shift lever assembly.

      Note


      • Securely install the end of the transmission control cable assembly to the shift lever assembly.

      • Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.

  3. ADJUST SHIFT LEVER POSITION

    Click here

  4. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01V1BGE02
      Text in Illustration
      *1 Shift Lever Knob Cover

      Turn the shift lever knob sub-assembly clockwise to install it to the shift lever assembly.

      Note

      Do not hold the shift lever knob cover when tightening the shift lever knob sub-assembly.

  6. INSTALL SHIFT LOCK RELEASE BUTTON COVER


    1. Engage the 2 claws to install the shift lock release button cover to the shift lever assembly.

  7. INSPECT SHIFT LEVER POSITION

    Click here