REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear disc brake dust cover and the rear axle hub and bearing assembly to the axle beam assembly with the 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. INSTALL SKID CONTROL SENSOR WIRE

    Click here

  5. INSTALL REAR DISC

    Click here

  6. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY

    Click here

  7. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  8. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  9. INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

    Click here

  10. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  11. INSPECT REAR WHEEL ALIGNMENT

    Click here

  12. INSPECT SPEED SENSOR SIGNAL

    Click here