REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

  4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  5. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY

    Click here

  6. REMOVE REAR DISC

    Click here

  7. SEPARATE SKID CONTROL SENSOR WIRE

    Click here

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. A004E57

      Remove the 4 bolts, rear axle hub and bearing assembly and the rear disc brake dust cover from the axle beam assembly.