TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. REMOVE ENGINE UNDER COVER LH

  2. REMOVE FRONT FLOOR CENTER BRACE

    Click here

  3. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  4. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    1. A01V117

      Remove the nut, 2 bolts and the front No. 1 floor heat insulator from the body.

  5. REMOVE REAR CONSOLE BOX

    Click here

  6. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01UYCC

      Disconnect the cable end from the shift lever assembly.

    3. A01V1DJE02
      Text in Illustration
      *1 Nut
      *a Rotate approximately 180°
      *b Pull out

      Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the shift lever plate.

      Note

      Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.

    4. A01UZSQE02
      Text in Illustration
      *1 No. 1 Transmission Control Cable Clamp
      *2 No. 2 Transmission Control Cable Clamp

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

      Note

      To prevent damage to the transmission control cable assembly and the shift lever assembly, disconnect the shift lever side of the transmission control cable assembly before disconnecting the transaxle side.

    5. Remove the clip and separate the transmission control cable assembly from the transmission control cable bracket.

    6. Separate the transmission control cable assembly from the No. 1 transmission control cable clamp and the No. 2 transmission control cable clamp.

    7. A01V0QW

      Remove the 4 nuts and the transmission control cable assembly from the body.

  7. REMOVE NO. 3 TRANSMISSION CONTROL CABLE CLAMP

    Tech Tips

    Perform this procedure only when replacement of the No. 3 transmission control cable clamp is necessary.


    1. A01UZAI

      Remove the nut and the No. 3 transmission control cable clamp from the body.