EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A01UYS6

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum 41.5 mm (1.64 in.)

      Tech Tips

      If the free length is less than minimum, replace the compression spring.

    2. Fully insert a new gasket to the exhaust manifold converter sub-assembly.

    3. A01UZP3E47
      Text in Illustration
      *1 Exhaust Manifold Converter Sub-assembly
      *2 Gasket
      *3 Wooden Block

      Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the exhaust manifold.

      Note


      • Be careful with the installation direction of the gasket.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • Do not push in the gasket by using the exhaust pipe when connecting it.

    4. Connect the front exhaust pipe assembly to the 3 exhaust pipe supports.

    5. Install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      Tech Tips

      After installation, check that the gaps between the flanges of the exhaust manifold and front exhaust pipe assembly are consistent front-to-rear and left-to-right.

      A01V0ZGE10
      Text in Illustration
      *1 Exhaust Manifold
      *2 Front Exhaust Pipe Assembly
      *3 Gasket
      *a Space between flanges: 8.5 mm (0.335 in.)

  2. INSTALL FRONT FLOOR CENTER BRACE

    Click here

  3. INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. A01UYS6

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum 38.5 mm (1.52 in.)

      Tech Tips

      If the free length is less than minimum, replace the compression spring.

    2. Fully insert a new gasket to the front exhaust pipe assembly.

    3. A01UZP3E48
      Text in Illustration
      *1 Front Exhaust Pipe Assembly
      *2 Gasket
      *3 Wooden Block

      Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the front exhaust pipe assembly.

      Note


      • Be careful with the installation direction of the gasket.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • Do not push in the gasket by using the exhaust pipe when connecting it.

    4. Connect the tail exhaust pipe assembly to the 2 exhaust pipe supports.

    5. Install the tail exhaust pipe assembly with the 2 compression springs and 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      Tech Tips

      After installation, check that the gaps between the flanges of the exhaust manifold and front exhaust pipe assembly are consistent front-to-rear and left-to-right.

      A01V0DFE02
      Text in Illustration
      *1 Tail Exhaust Pipe Assembly
      *2 Front Exhaust Pipe Assembly
      *3 Gasket
      *a Space between flanges: 6.5 mm (0.256 in.)

  4. INSPECT FOR EXHAUST GAS LEAK