HYBRID CONTROL SYSTEM, Diagnostic DTC:P0D2F-266, P0D30-267

DTC Code DTC Name
P0D2F-266 Drive Motor "A" Inverter Voltage Sensor Circuit Low
P0D30-267 Drive Motor "A" Inverter Voltage Sensor Circuit High

DESCRIPTION

The inverter contains a three-phase bridge circuit, which consists of six power transistors (IGBTs) each for MG1 and MG2. The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for generator (MG1) and motor (MG2); it also converts three-phase alternating current supplied by generator (MG1) and motor (MG2) into direct current for the HV battery. The MG ECU controls the actuation of the power transistors (IGBTs). The inverter transmits information necessary for control, such as amperage and voltage, to the MG ECU.

Tech Tips

The term "drive motor A" indicates motor (MG2).

A01UYE3E14

The MG ECU uses an inverter voltage sensor, which is built into the inverter, to detect boosted high voltage to allow control of the voltage boost.

The inverter voltage sensor outputs voltage that fluctuates between 0 to 5 V according to changes in VH.

The MG ECU monitors the inverter voltage sensor and detects the following malfunctions.

The MG ECU monitors the inverter voltage sensor and detects the following malfunctions.

DTC No. INF Code DTC Detection Condition Trouble Area
P0D2F 266

Inverter voltage (VH) signal is stuck low

Stores a DTC when the VH sensor signal is excessively low.

(1 trip detection logic)

 Inverter with converter assembly
P0D30 267

Inverter voltage (VH) signal is stuck high

Stores a DTC when the VH sensor signal is excessively high.

(1 trip detection logic)
Related Data List
DTC No. Data List
P0D2F-266 VH-Voltage after Boosting
P0D30-267

CAUTION / NOTICE / HINT

Tech Tips

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.


  1. Turn the ignition switch to ON (READY) and wait for 5 seconds or more.

PROCEDURE


  1. REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

    Click here

    Tech Tips

    The signal line from the inverter voltage (VH) sensor is connected to the MG ECU inside the inverter with converter assembly.


    NEXT

    COMPLETED