BACK DOOR OUTSIDE GARNISH INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 BACK DOOR OUTSIDE GARNISH PROTECTOR


    1. Clean the attachment surface.


      1. Using a piece of cloth, rub the double-sided tape off the back door outside garnish sub-assembly.

        Note


        • Installing the No. 1 back door outside garnish protector while old double-sided tape remains can cause adhesion failure.

        • Using a screwdriver or similar tool to remove the old tape can damage the surface and cause adhesion failure.

      2. Using a non-residue solvent, clean the attachment surface.

    2. Remove the peeling paper on a new No. 1 back door outside garnish protector.

      Note

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. A004FMJC01
      *a Mark-off Line

      Install the No. 1 back door outside garnish protector as shown in the illustration.

      Note

      Press the double-sided tape on the No. 1 back door outside garnish protector firmly to attach.

      Tech Tips


      • Align the No. 1 back door outside garnish protector with the mark-off line of the back door outside garnish sub-assembly.

      • Use the same procedure for both sides.

      Standard Measurement
      Area Measurement
      A 3.0 mm (0.118 in.)

  2. INSTALL BACK DOOR GARNISH MOULDING UPPER PROTECTOR


    1. Clean the attachment surface.


      1. Using a piece of cloth, rub the double-sided tape off the back door outside garnish sub-assembly.

        Note


        • Installing the No. 1 back door outside garnish protector while old double-sided tape remains can cause adhesion failure.

        • Using a screwdriver or similar tool to remove the old tape can damage the surface and cause adhesion failure.

      2. Using a non-residue solvent, clean the attachment surface.

    2. Remove the peeling paper on a new back door garnish moulding upper protector.

      Note

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. A004ETQC02
      *a Mark-off Line

      Install the back door garnish moulding upper protector as shown in the illustration.

      Note

      Press the double-sided tape on the back door garnish moulding upper protector firmly to attach.

  3. INSTALL SYMBOL EMBLEM


    1. Install the back door ornament to the symbol emblem.

    2. Engage the guide and 3 claws to install the symbol emblem.

  4. INSTALL NO. 2 BACK DOOR OUTSIDE GARNISH (w/o Rear View Monitor System)


    1. Engage the 2 claws to install the No. 2 back door outside garnish.

  5. INSTALL BACK DOOR OUTSIDE GARNISH


    1. Engage the 11 clips and install the back door outside garnish.

    2. w/ Lock Cylinder:


      1. Install the 7 bolts.

        Torque:
        4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

      2. Install the back door lock cylinder assembly with door unlock switch sub-assembly with the 2 bolts.

        Torque:
        4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

      3. Connect the connector.

    3. w/o Lock Cylinder:


      1. Install the 8 bolts.

        Torque:
        4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

  6. INSTALL REAR LIGHT ASSEMBLY LH


  7. INSTALL REAR LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.