RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT HEADLIGHT DIM RELAY


    1. Remove DIM relay from the No. 2 engine room relay block.

    2. A01V1SH

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the DIM relay.

  2. INSPECT H-LP RELAY


    1. Remove H-LP relay from the No. 2 engine room relay block.

    2. A01UZWN

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the H-LP relay.

  3. INSPECT FR FOG RELAY


    1. Remove FR FOG light relay from the No. 4 relay block.

    2. A01V1SH

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the FR FOG relay.

  4. INSPECT DRL RELAY


    1. Remove DRL relay from the No. 2 engine room relay block.

    2. A01V1SH

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the DRL relay.

  5. INSPECT BKUP LP RELAY


    1. Remove BKUP LP relay from the No. 2 engine room relay block.

    2. A01V1SH

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminal 1 and 2 10 kΩ or higher
      Battery voltage applied to terminal 1 and 2 Below 1 Ω

      If the result is not as specified, replace the BKUP LP relay.