REAR COMBINATION LIGHT ASSEMBLY(for Bulb Type Stop Light) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. A01UZV3E03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly LH)

      Disconnect the connector from the rear combination light assembly LH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K5-4 - K5-6 Light control switch OFF Below 1 V
      Light control switch in TAIL 11 to 14 V
      K5-1 - K5-6 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      K5-2 - K5-6 Turn signal switch OFF Below 1 V
      Ignition switch ON (IG) and Turn signal switch in LH 11 to 14 V (60 to 120 times per minute)
      K5-5 - K5-6 Shift lever not in R Below 1 V
      Shift lever in R 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.

  2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    1. A01V1OCE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly RH)

      Disconnect the connector from the rear combination light assembly RH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K6-4 - K6-6 Light control switch OFF Below 1 V
      Light control switch in TAIL 11 to 14 V
      K6-1 - K6-6 Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      K6-2 - K6-6 Turn signal switch OFF Below 1 V
      Ignition switch ON (IG) and Turn signal switch in RH 11 to 14 V (60 to 120 times per minute)
      K6-5 - K6-6 Shift lever not in R Below 1 V
      Shift lever in R 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.