INTEGRATION RELAY INSPECTION

PROCEDURE


  1. INSPECT NO. 1 INTEGRATION RELAY

    A01UXYFE03
    Text in Illustration
    *1 No. 1 Integration Relay - -

    1. EFI-MAIN Relay:


      1. A01UXJKE01
        Text in Illustration
        *1 No. 1 Integration Relay

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        (2E-1) - (2C-4) Battery voltage is not applied between terminals 2C-3 and 2C-2 10 kΩ or higher
        (2E-1) - (2C-4) Battery voltage is applied between terminals 2C-3 and 2C-2 Below 1 Ω

        If the resistance is not as specified, replace the No. 1 integration relay.

    2. HORN Relay:


      1. A01UXJKE01
        Text in Illustration
        *1 No. 1 Integration Relay

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        (2E-1) - (2C-8) Battery voltage is not applied between terminals 2C-6 and 2C-7 10 kΩ or higher
        (2E-1) - (2C-8) Battery voltage is applied between terminals 2C-6 and 2C-7 Below 1 Ω

        If the resistance is not as specified, replace the No. 1 integration relay.

    3. IG2 Relay:


      1. A01UXJKE01
        Text in Illustration
        *1 No. 1 Integration Relay

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        (2E-1) - (2D-4) Battery voltage is not applied between terminals 2D-2 and 2D-3 10 kΩ or higher
        (2E-1) - (2D-4) Battery voltage is applied between terminals 2D-2 and 2D-3 Below 1 Ω

        If the resistance is not as specified, replace the No. 1 integration relay.

    4. C/OPN Relay:


      1. A01UXJKE01
        Text in Illustration
        *1 No. 1 Integration Relay

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        (2D-5) - (2D-8) Battery voltage is not applied between terminals 2D-6 and 2D-7 10 kΩ or higher
        (2D-5) - (2D-8) Battery voltage is applied between terminals 2D-6 and 2D-7 Below 1 Ω

        If the resistance is not as specified, replace the No. 1 integration relay.