HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR

   
   
   1. 

      Text in Illustration

      *a	Fulcrum Length 30 mm (1.18 in.)
      *b	Fulcrum Length 260 mm (10.2 in.)

      Using SST, install the heated oxygen sensor onto the front exhaust pipe.

      SST

      09224-00010

      Torque:

      without SST

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      with SST

      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Tech Tips

      
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values Click here.

2. INSTALL EXHAUST MANIFOLD

   Click here