CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL O-RING


    1. B0040YSC01
      *a O-ring Groove
      *b Camshaft Position Sensor Tip

      Clean the O-ring groove of the camshaft position sensor.

      Note

      Make sure the O-ring groove is free of foreign matter.

    2. Apply protective tape around the part (A) shown in the illustration.

    3. Install a new O-ring to the camshaft position sensor.

      Note

      Set the O-ring on the tip of the camshaft position sensor and roll it into the O-ring groove with bare hands to install it.

    4. B00410XC03
      *1 O-ring
      *a OK
      *b NG
      *c Seam

      Check if the O-ring is twisted.

      Tech Tips

      Check the entire circumference of the seam of the O-ring for twisting.

    5. Remove the protective tape.

      Note

      Make sure to remove the protective tape and any tape adhesive residue.

  2. INSTALL CAMSHAFT POSITION SENSOR


    1. B0040VLE01
      Text in Illustration
      *1 O-ring

      Apply a light coat of engine oil to the O-ring on the camshaft position sensor.

    2. Install the camshaft position sensor with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    3. Connect the camshaft position sensor connector.

  3. INSPECT FOR OIL LEAK