RELAY ON-VEHICLE INSPECTION


  1. INSPECT REAR FOG LIGHT RELAY (RR FOG)


    1. A01NEVEE86

      Remove the rear fog light relay from the No. 1 relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the rear fog light relay.

  2. INSPECT BACK UP LIGHT RELAY (BK/UP LP)


    1. A01NEVEE86

      Remove the back up light relay from the No. 2 engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the back up light relay.