HEADLIGHT ASSEMBLY (for HID Headlight) DISASSEMBLY


  1. REMOVE NO. 1 HEADLIGHT BACK COVER


    1. A01NFUV

      Turn the No. 1 headlight back cover in the direction indicated by the arrow shown in the illustration, and remove it.

  2. REMOVE DISCHARGE HEADLIGHT BULB


    1. A01NFQW

      Separate the light control ECU socket as shown in the illustration.

    2. A01NCN9E01

      Release the set spring and remove the discharge headlight bulb as shown in the illustration.

      Note

      Do not touch the bulb glass.

  3. REMOVE NO. 1 HEADLIGHT BULB


    1. A01ND5E

      Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.

      Note

      Do not touch the bulb glass.

  4. REMOVE FRONT TURN SIGNAL LIGHT BULB


    1. A01NHHU

      Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

    2. Remove the front turn signal light bulb from the front turn signal light socket.

  5. REMOVE CLEARANCE LIGHT BULB


    1. A01NDUG

      Disengage the claw and disconnect the connector.

    2. Turn the clearance light bulb and clearance light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

    3. Remove the clearance light bulb from the clearance light socket.

  6. REMOVE HEADLIGHT LEVELING MOTOR


    1. A01NCSJ

      Align the notches of the headlight leveling motor and housing, and pull out the headlight leveling motor slightly.

      Tech Tips

      For the headlight leveling motor RH, rotate it symmetrical to the directional arrow shown in the illustration.

    2. A01NEHT

      Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.

  7. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING


    1. Remove the headlight leveling motor base packing.

      Note

      After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

  8. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY


    1. A01NH3H

      Disengage the claw and disconnect the connector.

    2. Remove the 4 screws and disconnect the headlight light control ECU sub-assembly.

    3. w/ AFS:


      1. A01ND9N

        Remove the 3 screws.

      2. Disconnect the connector and remove the headlight reflector.

    4. A01ND2W

      Disconnect the connector and remove the headlight light control ECU sub-assembly.

  9. REMOVE HEADLIGHT GASKET


    1. Remove the headlight gasket.

      Note

      After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

  10. REMOVE FRONT BUMPER BAR REINFORCEMENT


    1. A01NF59

      Remove the 2 screws.

    2. Disengage the 2 guides and remove the front bumper bar reinforcement.