LIGHTING SYSTEM, Diagnostic DTC:B2417, B2418

DTC Code DTC Name
B2417 Headlight Beam Level Control Motor LH Malfunction
B2418 Headlight Beam Level Control Motor RH Malfunction

DESCRIPTION

The headlight leveling motor receives a signal from the AFS ECU (headlight swivel ECU assembly) to operate. The AFS ECU (headlight swivel ECU assembly) receives a signal indicating the operating conditions of the headlight leveling motor.

DTC No. DTC Detection Condition Trouble Area
B2417
  • Malfunction in headlight leveling motor LH

  • Open or short in headlight leveling motor LH circuit


  • Headlight leveling motor LH

  • Harness or connector

  • AFS ECU (headlight swivel ECU assembly)

B2418
  • Malfunction in headlight leveling motor RH

  • Open or short in headlight leveling motor RH circuit


  • Headlight leveling motor RH

  • Harness or connector

  • AFS ECU (headlight swivel ECU assembly)

WIRING DIAGRAM

A01NEHHE03

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK
  2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (READY).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / AFS / Active Test.

    5. Check that the leveling motors operate.

      AFS
      Tester Display Test Part Control Range Diagnostic Note
      Drive The Leveling Motor UP Leveling motor upward operation ON/OFF

      ON: Move up

      OFF: Stop

      Drive The Leveling Motor DOWN Leveling motor downward operation ON/OFF

      ON: Move down

      OFF: Stop

      OK
      Headlight leveling motors operate normally.

    NG
    OK
  3. REPLACE HEADLIGHT LEVELING MOTOR


    1. Temporarily replace the headlight leveling motor with a new or normally functioning one Click here for HID Headlight, Click here for LED Headlight).

    2. Check for DTCs Click here.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK
  4. CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU)


    1. A01NH9TE14
      Text in Illustration
      *1

      Front view of wire harness connector

      (to AFS ECU (Headlight Swivel ECU Assembly))

      Disconnect the A53 AFS ECU (headlight swivel ECU assembly) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A53-15 (IG) - Body ground Power switch on (IG) 11 to 14 V

    NG
    OK
  5. CHECK HARNESS AND CONNECTOR (AFS ECU - BODY GROUND)


    1. A01NH9TE15
      Text in Illustration
      *1

      Front view of wire harness connector

      (to AFS ECU (Headlight Swivel ECU Assembly))

      Disconnect the A53 AFS ECU (headlight swivel ECU assembly) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A53-22 (E1) - Body ground Always Below 1 Ω

    NG
    OK
  6. CHECK HARNESS AND CONNECTOR (AFS ECU - HEADLIGHT LEVELING MOTOR)


    1. A01NEDTE02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to AFS ECU (Headlight Swivel ECU Assembly))

      *2

      Front view of wire harness connector

      (to Headlight Leveling Motor LH)

      *3

      Front view of wire harness connector

      (to Headlight Leveling Motor RH)

      Disconnect the A53 AFS ECU (headlight swivel ECU assembly) connector.

    2. Disconnect the A21 or A29 headlight leveling motor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      LH Side (B2417)
      Tester Connection Condition Specified Condition
      A53-3 (LHT) - A21-1 (LHB1) Always Below 1 Ω
      A53-27 (LH-) - A21-3 (LHE) Always Below 1 Ω
      A53-30 (LH+) - A21-2 (LHM+) Always Below 1 Ω
      A53-3 (LHT) - Body ground Always 10 kΩ or higher
      A53-27 (LH-) - Body ground Always 10 kΩ or higher
      A53-30 (LH+) - Body ground Always 10 kΩ or higher
      RH Side (B2418)
      Tester Connection Condition Specified Condition
      A53-4 (RHT) - A29-1 (RHB1) Always Below 1 Ω
      A53-28 (RH-) - A29-3 (RHE) Always Below 1 Ω
      A53-11 (RH+) - A29-2 (RHM+) Always Below 1 Ω
      A53-4 (RHT) - Body ground Always 10 kΩ or higher
      A53-28 (RH-) - Body ground Always 10 kΩ or higher
      A53-11 (RH+) - Body ground Always 10 kΩ or higher

    NG
    OK
  7. INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)


    1. A01NESHE05
      Text in Illustration
      *1

      Component with harness connected

      (AFS ECU (Headlight Swivel ECU Assembly))

      Reconnect the A53 AFS ECU (headlight swivel ECU assembly) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      LH Side (B2417)
      Tester Connection Condition Specified Condition
      A53-3 (LHT) - A53-27 (LH-) Power switch off Below 1 V
      Power switch on (IG) 11 to 14 V
      RH Side (B2418)
      Tester Connection Condition Specified Condition
      A53-4 (RHT) - A53-28 (RH-) Power switch off Below 1 V
      Power switch on (IG) 11 to 14 V

    NG
    OK
  8. REPLACE HEADLIGHT LEVELING MOTOR


    1. Temporarily replace the headlight leveling motor with a new or normally functioning one Click here for HID Headlight, Click here for LED Headlight).

    2. Check for DTCs Click here.

      OK
      DTC B2417 or B2418 is not output.

    NG
    OK