LIGHTING SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the lighting system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK


    NEXT

  3. INSPECT BATTERY VOLTAGE

    Standard Voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT

  4. INSPECT CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN communication system DTC is not output. A
      CAN communication system DTC is output. B

      B

      GO TO CAN COMMUNICATION SYSTEM
      A

  5. CHECK FOR DTC*


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC is not output. A
      DTC is output. B

      B

      Go to step 8
      A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table. A
      Fault is listed in Problem Symptoms Table. B

      B

      Go to step 8
      A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test Click here

    2. Terminals of ECU Click here


      NEXT

  8. ADJUST, REPAIR OR REPLACE


    NEXT

  9. CONFIRMATION TEST


    NEXT
    END