HEADLIGHT CLEANER SWITCH REMOVAL


  1. PRECAUTION (w/ Air Suspension)

    Note

    w/ Navigation System for HDD

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX (w/ Air Suspension)


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Air Suspension)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT PANEL GARNISH LH


    1. A01NGMK

      Using moulding remover B, disengage the 6 clips and remove the instrument panel garnish LH as shown in the illustration.

  5. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01NFNE

      Push the No. 1 switch hole base in the direction indicated by the arrow to disengage the 4 claws and 2 guides.

    2. Disconnect each connector and remove the No. 1 switch hole base.

  6. REMOVE HEADLIGHT CLEANER SWITCH ASSEMBLY


    1. A01NHRK

      Disengage the 2 claws and remove the headlight cleaner switch assembly as shown in the illustration.