REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. A01NF83

      Install the rear wiper motor and bracket assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

    3. Engage the clamp.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A01NHF0E05
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A01NGHL

      Install the rear wiper motor grommet.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A01NHR2E03
        Text in Illustration
        *1 Wiper Arm Serration

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor assembly:


      1. A01NELBE03
        Text in Illustration
        *1 Wire Brush
        *2 Wiper Pivot Serration

        Clean the wiper pivot serrations with a wire brush.

    4. A01NF9TE01
      Text in Illustration
      *1 Ceramic Line

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
      Standard Clearance
      Area Measurement
      A 30 mm (1.181 in.)

      Tech Tips

      Hold the wiper arm by hand while tightening the nut.

    5. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

  4. INSTALL REAR SPOILER SUB-ASSEMBLY


    1. Install the 2 pins.

    2. Install a new clip.

    3. A01NHE7

      Engage the clip and 2 pins to install the rear spoiler sub-assembly.

    4. A01NFME

      Install the 5 nuts.

      Torque:
      5.9 N*m  { 60 kgf*cm, 52 in.*lbf }

    5. Install the 2 hole plugs.

    6. Connect each connector.

  5. INSTALL UPPER BACK WINDOW PANEL TRIM


    1. A01NGB3E01
      Text in Illustration
      *1 2-piece Type Clip

      Engage the 7 clips and 6 claws to install the upper back window panel trim.