WIPER AND WASHER SYSTEM IG Power Source Circuit

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.

WIRING DIAGRAM

A01NH5JE16

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY AND BODY GROUND)


    1. A01NCX9E13
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Headlight Cleaner Control Relay)

      Disconnect the A33 headlight cleaner control relay connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A33-3 (IG) - Body ground Power switch off Below 1 V
      Power switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A33-4 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here