BACK DOOR OPENER SWITCH INSTALLATION


  1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY


    1. A01NFQB

      Install the back door opener switch assembly.

  2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. Install 2 bolts.

    2. Install 2 stud bolts.

    3. Install 2 new clips and 4 new gaskets on the back door outside garnish assembly.

    4. A01NHU7

      Engage the 2 clips and install the back door outside garnish sub-assembly.

    5. A01NHHZ

      Install the 4 nuts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

    6. Connect each connector.

  3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A01NH51E01
      Text in Illustration
      *1 2-piece Type Clip

      Engage the 2 claws and 16 clips to install the back door trim panel assembly.

    2. Install the 2 screws.

  4. INSTALL BACK DOOR SERVICE HOLE COVER LH


    1. A01NH4X

      Engage the 5 claws to install the back door service hole cover LH.

  5. INSTALL BACK DOOR SERVICE HOLE COVER RH


    1. A01NCYF

      Engage the 5 claws to install the back door service hole cover RH.

  6. INSTALL BACK DOOR UPPER TRIM COVER LH


    1. A01ND49

      Engage the 2 claws to install the back door upper trim cover LH.

  7. INSTALL BACK DOOR UPPER TRIM COVER RH


    1. A01NF17

      Engage the 2 claws to install the back door upper trim cover RH.

  8. INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01NHOL

      Engage the claw to install the No. 2 room light assembly.

  9. INSTALL BACK DOOR LOCK COVER


    1. A01NDAS

      Engage the 4 claws to install the back door lock cover.

  10. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)


    1. A01NFVY

      Engage the 6 claws to install the back door finish cover LH.

  11. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)


    1. A01NHW1

      Engage the 4 claws to install the back door trim base.

  12. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)


    1. A01NHXM

      Engage the 6 claws to install the back door finish cover RH.

  13. INSTALL DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)


    1. Connect the connector.

    2. A01NH9U

      Engage the 6 claws to install the door pull handle with switch.

  14. INSTALL TONNEAU COVER SUB-ASSEMBLY