FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time after Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE


    1. A01NHW7

      Disengage the 7 claws, 4 clips and guide, and remove the front door scuff plate LH.

      Tech Tips

      A part of the clip remains on the vehicle side.

    2. w/ Illumination:


      1. Disconnect the connector.

  5. REMOVE REAR DOOR SCUFF PLATE


    1. A01NEW9

      Disengage the 6 claws, 3 clips and guide, and remove the rear door scuff plate LH.

  6. REMOVE LOWER CENTER PILLAR GARNISH


    1. A01NDN3

      Disengage the 2 claws and 5 clips, and remove the lower center pillar garnish LH.

  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01NF76

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  8. REMOVE CENTER PILLAR GARNISH


    1. A01NHO4

      Remove the 2 screws.

    2. Using a clip remover, disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH and remove the center pillar garnish LH.

  9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01NETH

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01NDC0

      Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect each connector.

    4. A01NH3Q

      Remove the 2 bolts and front seat outer belt assembly.

  10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01NCMF

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.