PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A4A

DTC Code DTC Name
C1A4A Skid Control Buzzer Circuit

DESCRIPTION

Based on pre-crash control, the driving support ECU communicates to the driver to be careful. The driving support ECU performs this by sending a sounding signal to the skid control ECU assembly to sound the skid control buzzer.

When the skid control ECU assembly detects a malfunction in the VSC warning buzzer circuit, a malfunction signal is sent to the driving support ECU, and a DTC is stored. Although the skid control ECU assembly sends a malfunction signal to the driving support ECU, the electronically controlled brake system does not store a relevant malfunction detection DTC.

DTC No. DTC Detection Condition Trouble Area
C1A4A When the power switch is on (IG), a skid control buzzer circuit malfunction signal is received from the skid control ECU assembly.

  • Skid control buzzer

  • Skid control buzzer circuit

  • Skid control ECU assembly

  • Driving support ECU

INSPECTION PROCEDURE

Tech Tips

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection Click here.

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)


    1. Select the Active Test, use the intelligent tester to generate a control command, then check that the skid control buzzer sounds Click here.

      Chassis/ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      Buzzer Skid control buzzer sounds ON/OFF -
      OK
      Skid control buzzer sounds.

    NG

    GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here

    OK

  2. REPLACE SKID CONTROL ECU ASSEMBLY


    1. Replace the skid control ECU assembly Click here.


    NEXT

  3. CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)


    1. Using the intelligent tester, enter the following menus: Body / Pre-Crash 2 / DTC.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs.

      OK
      DTC C1A4A is not output.

    NG

    REPLACE DRIVING SUPPORT ECU Click here

    OK

    END (SKID CONTROL ECU ASSEMBLY WAS DEFECTIVE)