AIRBAG CUT-OFF SWITCH INSPECTION


  1. INSPECT AIRBAG CUT-OFF SWITCH


    1. Turn the power switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      Note

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01NG9BE02
      Text in Illustration
      *1

      Component without harness connected

      (Airbag Cut-off Switch)

      Disconnect the connector from the airbag cut-off switch.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      F85-2 (PMC+) - F85-1 (PMC-) Airbag cut-off switch is in ON position 360 to 440 Ω
      F85-2 (PMC+) - F85-1 (PMC-) Airbag cut-off switch is in OFF position 90 to 110 Ω

      If the result is not as specified, replace the airbag cut-off switch.