REAR AIRBAG SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR AIRBAG SENSOR


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01NGDW

      Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the rear airbag sensor.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

        A01NF7IE03
        Text in Illustration
        *1 Outer Connector Locking Sleeve - -

        Tech Tips

        When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

    5. Check that there is no looseness in the installation parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE COVER


    1. A01NFWF

      Engage the 2 claws and 3 clips.

    2. Install the rear seat side cover LH with the 2 clips.

  3. INSTALL REAR DOOR SCUFF PLATE


    1. A01NEW9

      Engage the 3 clips, guide and 6 claws, and install the rear door scuff plate LH.

  4. INSTALL REAR SEAT ASSEMBLY

    Tech Tips

    Refer to the procedure from Install Rear Seat Assembly Click here for LH Side, Click here for RH Side).

  5. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.