FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY


    1. A01NEZL

      Connect the 2 airbag connectors.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to only connect the connectors to each corresponding color.

    2. Push in the lock to install the airbag connector.

    3. Engage the clamp to install the instrument panel wire assembly to the front passenger airbag assembly.

  2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    1. A01NGQH

      Engage the 5 hooks.

    2. A01NE1RE01

      Push the front passenger airbag assembly to engage the 5 hooks.

    3. Engage the 2 pins.

    4. Install the 2 screws to install the front passenger airbag assembly.

      Text in Illustration
      *1 Pin
      *2 Hook

  3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY


    1. Engage the 5 claws and temporarily install the instrument panel safety pad assembly as shown in the illustration.

      CAUTION:

      Leaks of cold air may result in condensation in the instrument panel. This condensation may cause short circuits in electrical parts. Be sure to insert and fit the No. 1 heater to register duct and the No. 4 heater to register duct tightly to the No. 1 air duct sub-assembly.

      Note


      • Do not damage the instrument panel safety pad assembly.

      • Do not allow the wire harnesses to interfere with the surrounding parts.

    2. Install the 2 clips.

    3. Install the 6 bolts <C> and nut <H> or <I>.

    4. Install the 2 passenger airbag bolts <A> or <B>.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }
      A01NH9SE01
      Text in Illustration
      *1 Passenger Airbag Bolt <A> or <B> *2 Bolt <C>
      *3 Nut <H> or <I> *4 Clip
      *5 No. 1 Heater To Register Duct *6 No. 4 Heater To Register Duct
      *7 No. 1 Air Duct Sub-assembly - -

    5. Engage the 2 claws to connect the room temperature sensor.

    6. Engage each clamp.

    7. Connect each connector.

      A01NGZN

  4. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01NFC5

      Connect the connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  5. INSTALL NO. 1 CONSOLE BOX DUCT

    Tech Tips

    Refer to the procedure from Install No. 1 Console Box Duct Click here.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.