FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL


  1. REMOVE NO. 1 CONSOLE BOX DUCT

    Tech Tips

    Refer to the procedure up to Remove No. 1 Console Box Duct Click here.

  2. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01NDCVE01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  3. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY


    1. Disconnect each connector.

    2. Disengage each clamp.

    3. Disengage the 2 claws and disconnect the room temperature sensor.

      A01NGZN

    4. Remove the 2 passenger airbag bolts <A> or <B>.

    5. Remove the 6 bolts <C> and nut <H> or <I>.

    6. Remove the 2 clips.

    7. Disengage the 5 claws and remove the instrument panel safety pad assembly.

      Note


      • Do not damage the instrument panel safety pad assembly.

      • Do not allow the wire harnesses to interfere with the surrounding parts.

      A01NHKHE01
      Text in Illustration
      *1 Passenger Airbag Bolt <A> or <B> *2 Bolt <C>
      *3 Nut <H> or <I> *4 Clip

  4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the front passenger airbag assembly, keep the airbag deployment side facing upward.


    1. A01NE1RE01

      Remove the 2 screws and disengage the 2 pins.

    2. Lean the instrument panel and disengage the 5 hooks.

      Text in Illustration
      *1 Pin
      *2 Hook
    3. A01NDL0

      Disengage the 5 hooks to remove the front passenger airbag assembly from the instrument panel safety pad assembly as shown in the illustration.

  5. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY


    1. A01NH6LE01
      Text in Illustration
      *1 Protective Tape

      Disengage the clamp.

    2. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors to remove the instrument panel wire assembly from the front passenger airbag assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.