CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

Tech Tips

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing Click here.

Note

w/ Navigation System for HDD:

After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
Specification	Waiting Time
w/o Telematics Transceiver	60 sec.
w/ Telematics Transceiver	120 sec.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE ROOF HEADLINING ASSEMBLY

Tech Tips

Refer to the procedure up to Remove Roof Headlining Assembly Click here.
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
CAUTION:

When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Using a screwdriver with the tip wrapped with protective tape, disconnect the curtain shield airbag connector.
  
  Note
  
  When disconnecting any airbag connector, take care not to damage the airbag wire harness.
4. Remove the 10 bolts.
5. Disengage the 10 hooks to remove the curtain shield airbag assembly.