AIRBAG SYSTEM, Diagnostic DTC:B1630/23

DESCRIPTION

The rear airbag sensor RH circuit consists of the center airbag sensor assembly, side airbag sensor RH, and rear airbag sensor RH.

The side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.

DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor RH.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK REAR AIRBAG SENSOR RH

   
   
   1. 

      Text in Illustration

      *1	Rear Airbag Sensor LH
      *2	Side Airbag Sensor RH

      Turn the power switch off.

   2. Disconnect the cable from the negative (-) battery terminal.

      Note

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Interchange the rear airbag sensor LH with RH and connect the connectors to them.

   4. Connect the cable to the negative (-) battery terminal.

   5. Turn the power switch on (IG), and wait for at least 60 seconds.

   6. Clear the DTCs stored in the memory Click here.

   7. Turn the power switch off.

   8. Turn the power switch on (IG), and wait for at least 60 seconds.

   9. Check for DTCs Click here.

      Result
      Result Proceed to DTC B1630/23 and B1635/24 are not output. A DTC B1635/24 is output. B DTC B1630/23 is output. C

      Tech Tips

      Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

   
   

   B

   REPLACE REAR AIRBAG SENSOR RH Click here

   C

   REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here

   A

   USE SIMULATION METHOD TO CHECK Click here