Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Driver Seat Position | Driver Seat Position/ Forward: Seat position is forward Bkward: Seat position is backward Fail: Failure detected |
Forward/Bkward | - |
| Passenger Classification | Passenger Classification/ NG: Date is not determined OFF: Vacant Child: Child (less than 32 kg (70.6 lb)) is seated AF05: Adult (36 to 54 kg (79.37 to 119.05 lb)) is seated AM50: Adult (more than 54 kg (119.05 lb)) is seated Fail: A failure is detected |
OFF/Child/AF05/AM50 | - |
| Left Side Buckle SW | LH Side Buckle SW/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined |
Unset/Set | - |
| Right Side Buckle SW | RH Side Buckle SW/ Unset: The seat belt is not fastened Set: The seat belt is fastened NG: Data is not determined |
Unset/Set | - |
| Display Type Information | Display Type Information/ LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger |
LR | - |
| Number of Past DTC | Number of Past DTC/ Min.: 0, Max.: 255 |
0 | - |