ACCESSORY METER REMOVAL


  1. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. A01NDTPE01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover B
      *3 Moulding Remover D

      Apply protective tape to the areas shown in the illustration.

    2. Insert moulding remover B and D as shown in the illustration.

    3. Pull down moulding remover B in direction (1). With moulding remover B being pulled down, pull down moulding remover D in direction (2) to disengage the clip and guide.

    4. A01NHA9E01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover B
      *3 Moulding Remover D

      Apply protective tape to the areas shown in the illustration.

    5. Insert moulding remover B and D as shown in the illustration.

    6. Pull down moulding remover B in direction (1). With moulding remover B being pulled down, pull down moulding remover D in direction (2) to disengage the clip.

    7. A01NEJU

      Disengage the 2 clips and remove the center instrument cluster finish panel as shown in the illustration.

  4. REMOVE ACCESSORY METER ASSEMBLY


    1. A01NDLA

      Remove the 3 screws.

    2. Disengage the 2 clips.

    3. Disconnect each connector and remove the accessory meter assembly.