COMBINATION METER REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the auto tilt away function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing this operation.

      Tech Tips

      Performing the above operation disables the auto tilt away function when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off and disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT PANEL GARNISH LH


    1. A01NGMK

      Using moulding remover B, disengage the 6 clips and remove the instrument panel garnish LH as shown in the illustration.

  5. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01NFNE

      Push the No. 1 switch hole base in the direction indicated by the arrow to disengage the 4 claws and 2 guides.

    2. Disconnect each connector and remove the No. 1 switch hole base.

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A01NGE1

      Disengage the 2 claws and open the cover as shown in the illustration.

    2. A01NG78

      Remove the 2 screws <D>.

    3. Disengage the 8 clips and 2 guides.

    4. Disconnect each connector and remove the lower instrument panel finish panel sub-assembly.

  7. REMOVE NO. 1 INSTRUMENT PANEL HOLE COVER


    1. A01NF7HE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 2 claws and remove the No. 1 instrument panel hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

  8. REMOVE NO. 2 INSTRUMENT PANEL HOLE COVER

    Tech Tips

    Use the same procedure for the No. 2 instrument panel hole cover and No. 1 instrument panel hole cover.

  9. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL


    1. A01NGA6

      Remove the 2 clips and 2 screws.

    2. Disengage the 4 clips and 2 guides, and remove the No. 1 instrument cluster finish panel.

  10. REMOVE COMBINATION METER ASSEMBLY


    1. A01NCTD

      Remove the 2 screws.

    2. Disconnect each connector and remove the combination meter assembly.