METER / GAUGE SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    Parking Assist Monitor System

    Click here

    Side Monitor System
    Back Door Closer System
    Power Back Door System

  2. WARNING NOTIFICATION FUNCTION (w/ G-BOOK Service Contract)

    Note


    • Before performing inspections or repairs which may cause warning messages or DTC to occur, such as a simulation test or road test, it is necessary to activate warning notification restraint mode so that the G-BOOK center does not recognize the warnings as real ones.

    • Warning notification restraint mode can be entered by using the intelligent tester or operating the multi-display.

    Tech Tips

    The warning notification function sends a warning message signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the G-BOOK device if a warning is displayed in the vehicle due to a vehicle malfunction.


    1. Warning notification restraint mode

      Tech Tips


      • Performing the following procedure will select warning notification restraint mode.

      • After warning notification restraint mode is entered, driving the vehicle 10 km will cancel the mode.


      1. Warning notification restraint mode (Using the intelligent tester)


        1. Turn the power switch off.

        2. Connect the intelligent tester to the DLC3.

        3. Start the engine.

        4. Enter the following menus: Powertrain / Engine / DTC.

      2. Warning notification restraint mode (Operating the multi-display)


        1. Enter diagnostic mode of navigation system (for HDD) Click here.