LIGHTING SYSTEM OPERATION CHECK


  1. INSPECT ILLUMINATED ENTRY SYSTEM OPERATION

    Note

    Perform this inspection with the customize parameter at the initial setting.

    Tech Tips

    The illuminated entry system illuminates the lights below.


    • Power Switch Illumination

    • Front Interior Lights

    • Rear Interior Light

    • Footwell Lights

    • Scuff Plate Lights


    1. The operation and condition of this control are described below.

      Operation Condition
      Fade in and illuminate constantly Any door is opened when all doors are closed.
      Illuminate for 15 seconds, and then fade out

      When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out.


      • The key enters any actuation area around the doors when the power switch is off and all doors are closed*1.

      • Any door is unlocked when the power switch is off, all doors are closed and locked.

      • The power switch is turned from on (ACC) to off when all doors are closed.

      • All doors are closed when any door is opened and the power switch is off.
      Fade out immediately

      When any of the following conditions is met, the lights fade out immediately.


      • The power switch is turned from off to on (ACC) when all doors are closed.

      • All doors are locked when the power switch is off, all doors are closed and any door is unlocked.

      • All doors are locked again when all doors are closed and locked.
      Battery saver When no changes occur in the condition of the doors for 20 minutes and a key is not in the actuation area, these lights turn off.

      Tech Tips

      *1: When the lights are on, if the key leaves all of actuation areas around the doors, after approximately 3 seconds, the lights fade out.

  2. INSPECT CENTER CONSOLE SPOT LIGHT CONTROL OPERATION

    Note

    Perform this inspection with the customize parameter at the initial settings.

    Tech Tips

    The center console spot light control illuminates the light below.


    • Center console spot light


    1. The operation and condition of this control are described below.

      Operation Condition
      Fade in

      When either of the following conditions is met, the center console spot light fades in.


      • The power switch is on (ACC)

      • The power switch is on (IG)
      Fade out The power switch is off