ENGINE HOOD COURTESY SWITCH REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01NHKG

      Remove the 4 clips and engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NH7B

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NDNO

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE HOOD CENTER CUSHION


    1. A01NE5D

      Remove the 2 hood center cushions.

  5. REMOVE FRONT BUMPER ASSEMBLY


    1. A01NFTPE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01ND22

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01NDQH

      Remove the screw and front bumper seal bracket.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01NE3M

      Remove the 2 bolts and 2 screws.

    5. Using a clip remover, remove the 6 clips.

    6. A01NFX1

      Disengage the 4 claws and remove the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01NE8W

      Using a moulding remover, disengage the claw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. Disconnect the fog light connector.

    9. Disconnect the No. 1 ultrasonic sensor connector. (w/ LEXUS Parking Assist-sensor System)

    10. Disconnect the headlight cleaner hose.

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    11. A01NCNT

      Remove the front bumper assembly as shown in the illustration.

  6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    1. A01NFIV

      Disconnect the connector.

    2. Remove the 3 bolts and the millimeter wave radar sensor assembly.

  7. REMOVE LOW PITCHED HORN ASSEMBLY (for LHD)


    1. A01NG9V

      Disconnect the connector.

    2. Remove the bolt and low pitched horn assembly.

  8. REMOVE HIGH PITCHED HORN ASSEMBLY (for RHD)


    1. A01NDP3

      Disconnect the connector.

    2. Remove the bolt and high pitched horn assembly.

  9. REMOVE SMOG VENTILATION SENSOR (for RHD)


    1. w/ Smog Ventilation Sensor:


      1. Click here

  10. REMOVE HOOD LOCK CONTROL CABLE COVER


    1. A01NEIY

      Remove the 3 screws.

    2. Disengage the clamp and remove the hood lock control cable cover.

  11. REMOVE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. A01ND9B

      Using a screwdriver, remove the hood lock nut cap.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01NHTK

      Remove the 2 bolts and hood lock nut.

    3. A01NHW4

      Disconnect the connector.

    4. Disconnect the hood lock control cable and remove the hood lock assembly.