REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)
Using a 4 mm hexagon wrench, remove the 3 hexagon screws.
Remove the 2 screws and rear quarter panel mudguard sub-assembly.
REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY RH (w/ Rear Fender Mudguard)
Tech Tips
Use the same procedure for the RH side and LH side.
REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 screws and grommet.
Remove the 4 screws.
Remove the 2 bolts and 3 clips.
Disengage the 2 claws and remove the No. 2 luggage compartment side cover protector.
REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 bolts and 2 screws.
Remove the 2 clips and No. 1 luggage compartment side cover protector.
REMOVE REAR BUMPER ASSEMBLY
| *1 | Protective Tape |
Put protective tape around the rear bumper assembly.
Using a clip remover, remove the 2 clips.
Remove the 2 screws and 2 rear bumper upper stoppers.
Remove the screw.
Tech Tips
Use the same procedure for the RH side and LH side.
Disengage the 7 claws.
Tech Tips
Use the same procedure for the RH side and LH side.
Disconnect each connector.
Disengage the 4 claws and 4 guides, and remove the rear bumper assembly as shown in the illustration.
REMOVE REAR BUMPER ENERGY ABSORBER
Disengage the 2 guides and remove the rear bumper energy absorber.
REMOVE ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)
Disconnect the connector.
Remove the 2 nuts and electrical key oscillator (electrical key antenna).
Note
Be careful when removing the electrical key oscillator (electrical key antenna). If the oscillator is dropped, replace it with a new one.