ELECTRICAL KEY OSCILLATOR (for Front Floor) INSTALLATION


  1. INSTALL ELECTRICAL KEY OSCILLATOR


    1. A01NDRR

      Engage the clamp and install the electrical key oscillator.

      Note

      Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.

    2. Connect the connector.

  2. INSTALL CONSOLE BOX (for LHD)


    1. A01NF55E01
      Text in Illustration
      *1 Clamp
      *2 Guide

      Engage the 3 guides as shown in the illustration.

    2. Engage the 2 clamps.

    3. Install the 3 clips.

    4. A01NDJA

      Install the console box with the 5 screws <D>.

  3. INSTALL CONSOLE BOX (for RHD)


    1. A01NDV8E01
      Text in Illustration
      *1 Clamp
      *2 Guide

      Engage the 3 guides as shown in the illustration.

    2. Engage the 2 clamps.

    3. Install the 2 clips.

    4. A01NCM1

      Install the console box with the 5 screws <D>.

  4. INSTALL FRONT CONSOLE BOX COVER


    1. A01NHOI

      Connect the connector.

    2. Engage the 5 guides and 2 clips, and install the front console box cover.

  5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL


    1. A01NF11

      Engage the 7 clips to install the lower instrument panel finish panel as shown in the illustration.

  6. INSTALL INSTRUMENT PANEL FINISH PANEL


    1. A01ND4S

      Engage the 2 guides, claw and 2 clips to install the instrument panel finish panel as shown in the illustration.

  7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. A01NG78

      Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A01NE1K

      Engage the 2 claws to close the cover as shown in the illustration.

  8. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NFF7

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  9. INSTALL INSTRUMENT PANEL GARNISH LH


    1. A01NH3A

      Engage the 6 clips to install the instrument panel garnish LH.

  10. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Air Suspension)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSTALL REAR DECK FLOOR BOX (w/ Air Suspension)


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.

  13. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

    Click here