ENGINE IMMOBILISER SYSTEM, Diagnostic DTC:B278A

DTC Code DTC Name
B278A Short to GND in Immobiliser System Power Source Circuit

DESCRIPTION

This DTC is stored when the power switch power source supply line is open or shorted.

DTC No. DTC Detection Condition Trouble Area
B278A Power switch power source supply line is open or shorted.

  • Wire harness or connector

  • Power switch

  • Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM

A01NCV1E11

INSPECTION PROCEDURE

Note

If the certification ECU (smart key ECU assembly) is replaced, register the key.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Recheck for DTCs Click here.

      OK
      DTC B278A is not output.

    NG

    CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH)


    1. Disconnect the certification ECU (smart key ECU assembly) connector.

    2. A01NCLGE04
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Certification ECU (Smart Key ECU Assembly))
      *2

      Front view of wire harness connector

      (to Power Switch)

      Disconnect the power switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F58-28 (VC5) - F22-14 (VC5) Always Below 1 Ω
      F58-36 (AGND) - F22-8 (AGND) Always Below 1 Ω
      F58-28 (VC5) - Body ground Always 10 kΩ or higher
      F58-36 (AGND) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


    1. Reconnect the certification ECU (smart key ECU assembly) connector.

    2. Reconnect the power switch connector.

    3. A01NE3FE02
      Text in Illustration
      *1

      Component with harness connected

      (Power Switch)
      *2 GND

      Using an oscilloscope, check the waveform.

      Waveform (Reference)
      Item Content
      Tester Connection F22-14 (VC5) - F22-8 (AGND)
      Tool Setting 2 V/DIV., 200 ms./DIV.
      Condition

      • Power switch off

      • Key not in cabin

      • Power switch pressed within 30 seconds
      OK
      Waveform is output normally (see illustration)

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

    OK

    REPLACE POWER SWITCH Click here