ENGINE IMMOBILISER SYSTEM, Diagnostic DTC:B2784

DTC Code DTC Name
B2784 Antenna Coil Open / Short

DESCRIPTION

This DTC is stored when there is an open or short in the transponder key coil (built into the power switch).

DTC No. DTC Detection Condition Trouble Area
B2784 Transponder key coil is open or shorted.

  • Wire harness or connector

  • Power switch

  • Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM

A01NCV1E10

INSPECTION PROCEDURE

Note

If the certification ECU (smart key ECU assembly) is replaced, register the key.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Recheck for DTCs Click here.

      OK
      DTC B2784 is not output.

    NG

    CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH)


    1. Disconnect the certification ECU (smart key ECU assembly) connector.

    2. A01NCLGE03
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Certification ECU (Smart Key ECU Assembly))
      *2

      Front view of wire harness connector

      (to Power Switch)

      Disconnect the power switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F58-12 (TXCT) - F22-9 (TXCT) Always Below 1 Ω
      F58-13 (CODE) - F22-10 (CODE) Always Below 1 Ω
      F58-12 (TXCT) - Body ground Always 10 kΩ or higher
      F58-13 (CODE) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE POWER SWITCH


    1. Replace the power switch Click here.


    NEXT

  4. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Recheck for DTCs Click here.

      OK
      DTC B2784 is not output.

    NG

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

    OK

    END (POWER SWITCH WAS DEFECTIVE)