DOOR CONTROL TRANSMITTER REMOVAL


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A01NCLPE01

      Push and hold the release knob in the direction indicated by the arrow shown in the illustration. Then take the mechanical key out of the case.

    2. A01NCQU

      Insert a precision screwdriver into the gap, and turn the screwdriver to detach the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01NCWAE01

      Insert a screwdriver into the gap and remove the battery (lithium battery).

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may be damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

  2. REMOVE TRANSMITTER BATTERY (for Card Type)

    A01NCMZ

    1. Lightly hold and pull the transmitter cover out in the direction shown by the arrow in the illustration.

      Note

      Do not insert a screwdriver etc. between the case and transmitter cover and forcefully bend the transmitter cover. This will deform the transmitter cover.

      Tech Tips


      • If the transmitter cover is held too firmly, it becomes harder to pull out.

      • If the transmitter cover is slippery and it is difficult to pull it out, use non-slip gloves to pull the cover out.

    2. A01NEWP

      Remove the transmitter (card key) battery (lithium battery).