TRANSMITTER BATTERY REPLACEMENT


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A01NCLPE01

      Push and hold the release knob in the direction indicated by the arrow shown in the illustration. Then take the mechanical key out of the case.

    2. A01NCQU

      Insert a precision screwdriver into the gap, and turn the screwdriver to detach the cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01NCWAE01

      Insert a screwdriver into the gap and remove the battery (lithium battery).

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may be damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

  2. REMOVE TRANSMITTER BATTERY (for Card Type)

    A01NCMZ

    1. Lightly hold and pull the transmitter cover out in the direction shown by the arrow in the illustration.

      Note

      Do not insert a screwdriver etc. between the case and transmitter cover and forcefully bend the transmitter cover. This will deform the transmitter cover.

      Tech Tips


      • If the transmitter cover is held too firmly, it becomes harder to pull out.

      • If the transmitter cover is slippery and it is difficult to pull it out, use non-slip gloves to pull the cover out.

    2. A01NEWP

      Remove the transmitter (card key) battery (lithium battery).

  3. INSTALL TRANSMITTER BATTERY


    1. A01NDA6E01

      Install a battery (lithium battery) with the positive (+) side facing upward, as shown in the illustration.

      Note


      • Be sure that the positive (+) side and the negative (-) side of the transmitter battery are matched correctly.

      • Be careful not to bend the electrodes while installing the battery.

      • Keep the interior of the transmitter case free of dust, water and oil.

    2. A01NHQEE01

      Install the cover by pressing down on it as shown in the illustration.

    3. A01NH9O

      Insert the mechanical key into the transmitter.

    4. Press one of the transmitter switches and check that the LED illuminates.

  4. INSTALL TRANSMITTER BATTERY (for Card Type)


    1. A01NHJW

      Push in and install the transmitter battery (lithium battery) while being careful of the following: 1) the orientation of the battery positive (+) and negative (-) terminals; and 2) being sure to insert the battery between the 2 terminals and deep into the card, in the direction shown by the arrow in the illustration.

      Note


      • Insert the battery so that its positive (+) side is facing the LEXUS mark.

      • Do not deform the terminals.

      • If the terminals are dirty, wipe the terminals with a soft cloth before installing the battery.

      Tech Tips

      Check if the card terminals are damaged or if the card interior has foreign matter.

    2. A01NCQ7

      Install the transmitter cover so that it clips onto the case.

      Note


      • Push on the transmitter cover until its attachment hooks attach securely.

      • When the transmitter cover is removed and installed many times, be careful as the cover may become loose.