WIRELESS DOOR LOCK CONTROL SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Data List.

    5. Read the Data List according to the display on the intelligent tester.

      Main Body (Main Body ECU (Multiplex Network Body ECU))
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Wireless Control Wireless door lock control function/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Hazard Answer Back Hazard answer-back of wireless/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Open Door Warning*1 Open door warning/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Unlock 2 Operation 2 times operation of wireless unlock/ON or OFF

      ON: All doors unlock when unlock switch pressed twice

      OFF: All doors unlock when unlock switch pressed once

      		 -
      Panic Function*2 Panic function/ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Auto Lock Time Automatic lock time/120 s, 60 s or 30 s

      120 s: 120 seconds

      60 s: 60 seconds

      30 s: 30 seconds

      		 -

      • *1: w/ Door ajar warning function

      • *2: w/ Panic Function

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Active Test.

    5. Perform the Active Test according to the display on the intelligent tester.

      Main Body (Main Body ECU (Multiplex Network Body ECU))
      Tester Display Test Part Control Range Diagnostic Note
      Hazard Turn signal flasher relay ON/OFF Observe headlights and rear combination lights for correct operation
      Illuminated Entry System Interior lights and ignition key cylinder light (Interior light switch is in door position and all doors are closed) ON/OFF -
      Wireless Buzzer*1 Wireless door lock buzzer ON/OFF -
      Vehicle Horn Vehicle horns ON/OFF -
      Security Horn*2 Security horn ON/OFF -

      • *1: w/ Wireless buzzer answer back function

      • *2: w/o Theft Warning Siren