HOOD REASSEMBLY


  1. INSTALL HOOD SUPPORT ASSEMBLY LH

    Note


    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.


    1. When reusing the back door stay assembly:


      1. A01NH2V

        Install the 2 stop rings to the hood support assembly.

    2. A01NH6B

      Install the hood support assembly.

      Note

      Install the hood support assembly while supporting the hood by hand.

    3. Check that the hood support assembly is engaged in the ball joint and it cannot be pulled out.

  2. INSTALL HOOD SUPPORT ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  3. CONNECT WASHER HOSE ASSEMBLY


    1. A01NFYK

      Engage the 5 clips and connect the washer hose assembly.

  4. INSTALL WASHER NOZZLE SUB-ASSEMBLY


    1. A01ND7H

      Connect a new washer nozzle sub-assembly to the washer hose.

    2. A01NG0DE01

      Engage the 2 claws and install the washer nozzle sub-assembly as shown in the illustration.

  5. INSPECT WASHER NOZZLE SUB-ASSEMBLY


    1. With the engine running, check the position that the washer fluid hits the windshield.

      Standard
      Washer fluid hits the windshield in the areas shown in the illustration.
      A01NF43E01
      Standard Clearance
      Area Measurement
      A 240 mm (9.449 in.)
      B 254 mm (10.00 in.)
      C 113 mm (4.449 in.)
      D 89 mm (3.504 in.)

      Tech Tips

      If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.

  6. ADJUST WASHER NOZZLE SUB-ASSEMBLY


    1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.

      A01NGWXE01

  7. INSTALL HOOD INSULATOR


    1. A01NDI2

      Engage the 2 claws.

    2. Install the hood insulator with the 9 clips.

  8. INSTALL HOOD TO RADIATOR SUPPORT SEAL


    1. A01NDH7

      Engage the 10 clips and install the hood to radiator support seal.

  9. INSTALL HOOD AUXILIARY CATCH HOOK ASSEMBLY


    1. A01NEGS

      Install the hood auxiliary catch hook assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }