POWER MANAGEMENT CONTROL ECU (for RHD) INSTALLATION

INSTALL POWER MANAGEMENT CONTROL ECU
1. Engage the 2 claws to install the power management control ECU.
INSTALL ECU INTEGRATION BOX
1. Install the ECU integration box with the bolt and 2 nuts.
  
  Torque:
  
  5.5 N*m { 56 kgf*cm, 49 in.*lbf }
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Tech Tips

Use the same procedure for the RHD and LHD Click here.
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

Tech Tips

Use the same procedure for the RHD and LHD Click here.
INSTALL INSTRUMENT PANEL GARNISH LH
1. Engage the 6 clips to install the instrument panel garnish LH.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Tech Tips

Use the same procedure for the RHD and LHD Click here.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
1. Engage the 2 clips to install the cowl side trim sub-assembly LH.
2. Install the clip.
INSTALL FRONT DOOR SCUFF PLATE LH
1. w/ Illumination:
  1. Connect the connector.
2. Engage the 4 clips, guide and 7 claws, and install the front door scuff plate LH.
INSTALL INSTRUMENT PANEL FINISH PANEL
1. Engage the 2 guides, claw and 2 clips to install the instrument panel finish panel as shown in the illustration.
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Tech Tips

Use the same procedure for the RHD and LHD Click here.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
1. Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL REAR DECK FLOOR BOX
1. Install the rear deck floor box with the 3 clips.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light Click here.